NWEA149892B · Novalk · Exterior · Water-Based
White Exterior For Metal, Wood, & Plastic
White Exterior For Metal, Wood, & Plastic
Product images are representative. Containers, labels, and packaging may differ from what's shown.
About this product
Novalk 892 white is the catalyzed exterior finish: a fast-drying, high-solids 2K white topcoat (about 43% solids) with UV blockers, built for the surfaces that take the most weather and the most handling. It bonds to wood, metal and plastic with the right prep, and cures to a hard, anti-scratch, scrubbable white with excellent coverage and vertical hang. It self-seals in two coats.
Where it fits. Painted exterior doors and entry systems, outdoor furniture, railings, shutters, and metal or composite parts. Over 861B white primer on bare or tannin-prone wood.
Mixing. 892 must be catalyzed; there is no 1K option. Add 15% hardener by volume:
- NCW-105 long pot life: about 4 hours
- NCW-80: about 3 hours of pot life
Don't run the catalyzed mix through a pre-heater.
Application. One or two coats, with surface, product and air above 54°F. Recoat within 3 hours if a second coat is needed.
- Airless: 310 or 410 fine-finish tip at 1,700 to 2,200 psi
- HVLP: 4- or 5-stage turbine minimum, 1.8, 2.0 or 2.5 needle, reduce up to 10% with 1034 flow reducer if needed
Novalk data sheet (rev. 8-2026).
- Spread rate: 125 to 150 g/m² per coat
- Vertical hold: 250 microns wet (about 10 mils)
- Yield: 3 to 4 m² per kg (about 32 to 43 sq ft per kg)
Exterior use. Low VOC, zero emissions, water clean-up. Sheens 15 and 30 in 4 KG. Meets or exceeds KCMA standards for heat and humidity, cold check, chemical resistance and film swell. White base, tintable with NPW water-based pigments.
Documentation
Configure your order