NWIF179917B · Novalk · Water-Based
White Water Based 1K/2K Fast Drying Tannin Blocking HS Primer
White Water Based 1K/2K Fast Drying Tannin Blocking HS Primer
Product images are representative. Containers, labels, and packaging may differ from what's shown.
About this product
The primer the Novalk cabinet system is built on. 917B is a high-build white primer (about 60% solids) with a tannin-blocking additive, so oak, cherry and previously stained doors don't bleed through a white topcoat. It is thixotropic, which means it hangs on a vertical door without sagging, and it dries fast enough that a second coat can go on wet-on-wet. When it's dry it sands like chalk. Two coats over a scuff-sanded surface, a 320-grit sand, and the door is ready for topcoat.
Where it fits. First coat on scuff-sanded factory finishes, raw wood and stained cabinetry, under any Novalk water-based white topcoat (932, 934, 982). On badly stained or water-marked wood, put a coat of the 951 isolator underneath.
Mixing. Use it straight from the can as a 1K primer, or add 5% hardener by volume for extra adhesion and blocking:
- NCW-105 long pot life: about 4 hours
- NCW-80: about 3 hours of pot life
Don't run a catalyzed mix through a pre-heater.
Application. One or two coats at 4 to 5 wet mils.
- Airless: 308/408 or 310/410 fine-finish tip at 1,600 to 2,100 psi
- HVLP: 4- or 5-stage turbine minimum, 1.8 or 2.0 needle
- Reduce 5 to 10% with warm water or 1034 flow additive only if the gun needs it; 10% is the ceiling
Novalk data sheet (rev. 8-2026).
- Spread rate: 100 to 120 g/m² per coat
- Vertical hold: 140 microns wet
- Yield: 3 to 4 m² per kg (about 32 to 43 sq ft per kg)
Interior use. Low VOC, zero emissions, water clean-up. White, or a tint base for colored primer under deep topcoats. Stocked in 5 KG and 25 KG.
Documentation
Configure your order